Skip to content
RenoktaRenokta

Cold chain temperature monitoring: a setup guide

In the cold chain the goal is to prove a product stayed inside its allowed range at every moment. That takes the right measuring points, delayed alarms and continuous records.

Request a demo

Renokta Ekibi ·

A cold room refrigeration unit with compressor, fans and temperature control gauges.
Cold chain monitoring flow
MeasuringpointsSensorplacementContinuousmeasurementDelayedalarmRecordsand audit
  1. 1. Measuring pointsA trial measurement finds the warmest and coldest spots.
  2. 2. Sensor placementTemperature, humidity and door sensors go at product level.
  3. 3. Continuous measurementReadings are sent to the platform without gaps.
  4. 4. Delayed alarmA breach alerts the operator first, then a manager if unanswered.
  5. 5. Records and auditReadings and calibration dates are kept for audits.

Cold chain temperature monitoring proves, through continuous measurement, that a product stayed inside its allowed range during storage and transport. The system has two jobs: report an excursion immediately and document the process afterwards. That takes the right measuring points, delayed alarms and continuous records.

What should you measure in the cold chain?

Measure air temperature and humidity, product temperature and door state.

  • Air temperature and humidity: inside the room or cabinet, at product level.
  • Product temperature: with a probe in the product or a buffer liquid standing in for it, when needed.
  • Door state: an open door is one of the most common causes of excursions.

Where should the sensors go?

Place sensors at the warmest and coldest spots of the room, because one sensor does not represent a whole room. The area near the evaporator, the doorway and still corners give different readings. Find these spots with a trial measurement. Putting a sensor directly in the cooler airflow or by the door gives misleading values.

How do you set up temperature alarms?

Alarms should follow the product definition and be smart enough to avoid false alerts.

  • Set thresholds from the product definition; an alarm too close to the limit produces constant false alerts.
  • Add a delay for short fluctuations such as opening a door.
  • Escalate: first to the operator, then to a manager if unanswered.
  • Alarm on lost connection or low battery too; silence is not a normal reading.

How do records serve as audit evidence?

Continuous, tamper-resistant records are the strongest evidence in an audit. Calibration dates of the sensors should be recorded too. HACCP records for food and storage-condition records for medicines are typically fed by this data; check the relevant regulation and your quality manager for exact requirements.

What are common cold chain monitoring mistakes?

The most common mistake is relying on a single sensor and settings that never change.

  • Monitoring a whole room with one sensor.
  • Not naming who receives alarms, or not updating it at shift changes.
  • Not watching battery and connection status.
  • Setting alarm limits once and never reviewing them.

Renokta works with LoRaWAN temperature and humidity sensors in its cold chain solution; details are on the solution page.

Frequently asked questions

Where should a cold chain temperature sensor be placed?
At the warmest and coldest spots of the room, at product level, found with a trial measurement. Placing it in the cooler airflow or by the door gives misleading values.
Is one sensor enough for a cold room?
No. The area near the evaporator, the doorway and still corners give different readings, so one sensor does not represent the whole room.
Why does a temperature alarm need a delay?
Short fluctuations such as opening a door would cause constant false alarms. A delay means only lasting deviations are reported.
What should happen when a sensor loses connection?
An alarm should be raised on lost connection or low battery too. Silence is not a normal reading; missing data is a problem in itself.
Why do temperature records matter in an audit?
Continuous, tamper-resistant records are evidence that the product stayed in range. Record calibration dates too, and check the relevant regulation for exact requirements.

Let's plan the right solution for you, together.

Request a demo